31025 R0
29
Figure 13.
X-Tend Hopper Operator Controls
SWING
TIP-UP
Patents: CA 2,683,843; US 7,946,416; Other Patents Pending
5.4. Start-Up and Break-In
Your X-Tend hopper does not require an elaborate break in. However, following a few simple tips during the
initial operation can add to the reliability and life of your machine.
If any unusual noises or vibrations are encountered, determine the source, shut the auger off, lock out the
power source and adjust. If unsure of the problem or procedure, contact your local Wheatheart dealer.
1. Start the tractor and run at low idle.
2. Engage the tractor PTO and slowly increase to operating speed. Operate at 3/4 capacity for the first few
truckloads to break in the new components.
3. Place the tractor hydraulic control lever in detent.
Important
When starting the X-Tend hopper for the first time, be prepared for an emergency shut down in
case of excessive vibration or noise.
5.4.1 Prior to First Use
1. Re-torque all other fasteners and hardware, if required.
X-TEND HOPPER – X130
Содержание WHEATHEART X130
Страница 9: ...31025 R0 9 BIN X TEND HOPPER X130 2 SAFETY...
Страница 45: ...31025 R0 45 X TEND HOPPER X130 9 APPENDIX...