AGI NECO D16106, Инструкция по сборке, Страница: 99 / 122

7713397 R2 99
Example 3: Wet 1 and Wet 2 Augers and Dry 1 and Dry 2 Augers
The following diagram show two wet systems and two dry systems to be controlled and operated by the
Commander system.
Note
Shown for example only. Individual configuration vary.
Figure 123. Wet 1 and Wet 2 Augers and Dry 1 and Dry 2 Augers
4.7.13 Commander Control Setup
Note
The setup of the Commander control system is detail in the Commander Control Owner's and Operator's
Manual.
The dryer configuration information is input at the factory prior to system testing. This type of information
includes:
• Language
• The dryer system's measurement units are either set to Imperial or metric. Imperial units output
temperature in Fahrenheight and volume in bushels. Metric units output temperature in Celsius and volume
in cubic meters.
• The type of fuel supplied to the system.
• The dryer system's number of blowers and burners.
• Output gear motor RPM.
• The number of tiers in each blower/burner section.
After installation, the Fill/Empty setup and Timers setup are completed by the customer. This type of
information includes:
• If optional sensors are present (e.g. wet bin empty or dry bin full)
• Presence of additional auxiliary equipment (e.g. unload auger system, etc.)
• Maximum metering roll speed
• Various timers (e.g. cooling time, metering roll start time, etc.)
CONTINUOUS-FLOW GRAIN DRYER – COMMANDER CONTROL 4. ASSEMBLY