AGI NECO D16106, Инструкция по сборке, Страница: 39 / 122

7713397 R2 39
Table 7 Level Auger for Various Dryer Sizes (continued)
24' 023200 045007
Level Auger Cover
16' 7714718
N/A
24'
7714717 7714718
7715093 7715094
7715096
Level Auger Cover Plate
16' 040421
N/A
24' 040421 044872
1. Using 1/2" hardware, bolt the connecting shaft(s), drive shaft, and idler shaft to the level augers and
extension auger(s) as needed.
Figure 24. Auger Shaft Connections
1/2"
NUT
1/2" x 2" BOLT (6" & 8")
1/2" x 2 1/2" BOLT (10" & 12")
TYP - ALL CONNECTIONS
DRIVE SHAFT
(WITH KEY)
CONNECTION SHAFT
LEVEL AUGER
Note
Ensure the drive end of the shaft (with the keyway) is on the same end as the motor.
2. Position the end plates at both ends of the auger assembly, and then place the 044756 insert bearings and
035116 flangettes on both ends.
3. Using 3/8" hardware, pre-assemble the bearings and flangettes to the end plates at both ends, but DO NOT
tighten locking collars on the bearings until later in the process.
CONTINUOUS-FLOW GRAIN DRYER – COMMANDER CONTROL 4. ASSEMBLY