SE-Power FS STO-manual vers. 1.6 en.12.08.2015
31
5.1.1
Mounting the safety module
1.
Insert the safety module SE-Power FS Safety
Module STO into the extension slot for safety
modules so that the board runs in the lateral
guides of the slot.
2.
Insert safety module; when the back of the
contact strip within the servo drive is reached,
carefully press it into the contact strip until it
stops.
3.
Then screw the safety module with the two
screws onto the front of the servo drive housing.
Tighten the screws with approx. 0.35 Nm.
Figure 6:
Mounting / Dismounting
5.1.2
Dismounting the safety module
1.
Unscrew screws on the safety module.
2.
Loosen the safety module by gently levering the front cover or by pulling on the counter
plug by just a few millimetres.
3.
Pull the safety module out of the slot.