59
15.. Thread the quick link half way onto the
threaded coupler then install the quick link
onto the throttle servo arm. Position the throt-
tle servo arm at center travel and the carbure-
tor arm at center travel. With the quick link
attached to the throttle servo arm., mark the
location to cut the throttle pushrod to correct
length.
16.
Remove ball link from throttle arm and re-
move the throttle pushrod.
17.
Cut throttle push rod to correct length.
18. Using sand paper remove any paint from push-
rod at location of solder joint. This will give you
a stronger solder joint. Place the threaded
coupler over the pushrod. Solder coupler to
throttle
pushrod.
Note:
It is recommended to use a good quality silver
solder for a secure solder joint.
