16
Aeroworks 30cc Laser 200 Assembly Manual
3. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the trailing edge of the stabilizer. Apply epoxy
to one side of each hinge and insert the hinge
completely into the hole. Ensure the hinge axis
is horizontal and parallel to the trailing edge of
the stab before epoxy cures. Wipe away excess
epoxy with alcohol wetted wipes.
4. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the leading edge of the elevators. Apply epoxy
to trailing edge of each hinge.
5. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the trailing edge of the fin. Apply epoxy to one
side of each hinge and insert the hinge
Completely into the hole. Ensure the hinge axis
is vertical and parallel to the trailing edge of the
fin before epoxy cures. Wipe away excess epoxy
with alcohol wetted wipes.
6. Mix epoxy in mixing cup and use a tapered stick
to apply the epoxy inside the pre-drilled holes in
the leading edge of the rudder. Apply epoxy to
trailing edge of each hinge.
7. Carefully slide the rudder onto each hinge and
against the trailing edge of the fin. Wipe away
excess epoxy with alcohol wetted wipes.
ELEVATOR SERVO
INSTALLATION
1. Gather the items shown below for the elevator
servo installation.
Required Parts
◊
1 - 3” Pushrod
◊
1 - 4-40 Ball Link Assembly
◊
1 - Brass Spacer
◊
1 - Flat Washer
◊
1 - Lock Nut
◊
1 - 4-40 Lock Bolt
Required Parts-Not Supplied
◊
1 - Elevator Servo
◊
1 - 1 1/4” Servo arm
◊
1 - 24” servo extension
◊
1 - Aeroworks safety clip
◊
4 - Servo mounting screws
(Micro Fastener
Part number
STW0209
recommended)
Required Tools and Adhesives
◊
1 - 5/64” Ball Driver
