Advanced Energy THYRO-AX, Руководство пользователя

Страница: 82 / 117

48 49
The events, which are captured by the Thyro-AX, are shown on the
touch display in abbreviated form in a list. They correspond with the full
forms in their meaning and can be discerned using the table above.
6.8.2 FAULT SIGNALING RELAY K1
NOTE
DEFAULT SETTING
The function explained here is described in its default setting.
This setting can be altered with the control panel, with a bus module,
or with the Thyro-Tool AX.
FIG. 7 CONTACT
ASSIGNMENT
FAULT
SIGNALING
RELAY K1
DESCRIPTION THYRO-TOOL AX MESSAGE DISPLAY RELAY** PULSE INHIBIT DATA
OF STATUS MESSAGE ON DISPLAY LIGHTING RED LOGGER
PULSES ARE SWITCHED ON IMPULSE ON PULSE ON -
PULSE OFF AT PULSE SWITCH OFF PULOFFT X -
TERMINAL X2.1-X2.2 TERMINAL
PULSE OF AT PULSE SWITCH OFF PULOFFHW X - X
HARDWARE (ERROR) HARDWARE ERROR
PULSE OF AT SOFTWARE PULSE SWITCH OFF PULOFFEV X - X
(CONFIGURABLE) EVENT
PULSE OF EXTERNAL PULSE SWITCH OFF PULOFFEX X -
EXTERN
LEFT ROTATING FIELD LEFT ROTATING FIELD LEFTROTF X X X
(MESSAGE ONLY)
U LIMIT U LIMIT U LIMIT X
I LIMIT I LIMIT I LIMIT X
P LIMIT P LIMIT P LIMIT X
IPEAK LIMIT I PEAK LIMIT IPEAKLIMIT X
ALPHA IS RESTRICTED ALPHA RESTRICTED ALPHA
TS IS RESTRICTED SWITCH ON TIME TS
RESTRICTED
MAXIMUM CONTROLLER MAXIMUM OUTPUT MAXCONTROL
OUTPUT IS REACHED REACHED
SETPOINT OF BUSMODULE BUSMODULE BUS SETP
IS ACTIVE SETPOINT ACTIVE
BUSMODULE IS CONNECTED BUSMODULE BUS CONN
CONNECTED
CLOCK IST NOT SET CLOCK NOT SET NO CLOCK
POWER UNITS ARE HIGHER POWER UNIT DIFF PPART X
THAN TYPE DIFFERENT
POWER CONTROLLER IS OK POWER CONTROLLER THYRO OK -
OK
* = cannot be deactivated
** = default setting of fault signaling relay K1: closed circuit principle
DESCRIPTION THYRO-TOOL AX MESSAGE DISPLAY RELAY** PULSE INHIBIT DATA
OF MONITORING MESSAGE ON DISPLAY LIGHTING RED LOGGER
U
MAINS
MIN U MAIN < MINIMUM UN MIN X
U
MAINS
MAX U MAIN > MAXIMUM UN MAX X
U
LOAD
MIN U < MINIMUM UL MIN X
U
LOAD
MAX U > MAXIMUM UL MAX X
I
LOAD
MIN I < MINIMUM IL MIN X
I
LOAD
MAX I > MAXIMUM IL MAX X
P
LOAD
MIN P < MINIMUM PL MIN X
P
LOAD
MAX P > MAXIMUM PL MAX X
R
LOAD
MIN R < MINIMUM RL MIN X
R
LOAD
MAX R > MAXIMUM RL MAX X X X
I
PEAK
MAX I PEAK > MAXIMUM I_PEAK MAX X
MAX. TEMP. OF HEAT SINK TEMPERATURE UNIT > T_HEAT MAX X X X
MAXIMUM
* = cannot be deactivated
** = default setting of fault signaling relay K1: closed circuit principle
TAB. 5 STATUS
TAB. 6 MONITORING