ADTRAN TOTAL ACCESS 600R, Системное руководство

Страница: 86 / 196

Section 4 User Interface Guide Total Access 600R System Manual
86 © 2002 ADTRAN, Inc. 61200600L1-1A
R
OUTER
> C
ONFIG
> I
NTERFACES
(T1[0])
Configure the T1 interface parameters from this menu.
R
OUTER
> C
ONFIG
> I
NTERFACES
(T1[0])> S
UB
-I
NTERFACE
The T1 sub-interface is PPP [0.0] if the L2 Protocol is set for
PPP
. The [0.0] represents the T1 physical and
logical ports, respectively. This is a read-only field.
The T1 sub-interface is FRE [0.X] if the L2 Protocol is set for
F
RAME
R
ELAY
. The [0.X] represents the T1
physical and logical ports, respectively. The T1 physical port is always 0. The X represents the Frame
Relay logical port and will be a number between 0-9 corresponding to the interface number under
L2 P
ROTOCOL
>
C
ONFIG
>
DLCI M
APPING
. This is a read-only field.
R
OUTER
> C
ONFIG
> I
NTERFACES
(T1[0]) > S
ET
-
UP
Configure the addressing, address mode, MTU, NAT, and RIP parameters from this menu.
The 0 in T1[0] represents a physical port. The T1 physical port will always be 0.
The T1 interface will not appear in the
R
OUTER
> C
ONFIG
> I
NTERFACES
table if the
L2
P
ROTOCOL MODE
is set for
B
RIDGE
A
LL
. The T1 interface will not appear if a DLCI is not
entered in the
DLCI M
APPING
table (
L2 P
ROTOCOL
(T1[0]-FRE) > C
ONFIG
> DLCI M
APPING
)
when the
L2 P
ROTOCOL
is set to Frame Relay (
FRE
).
A
CTIVE
This option allows this DLCI to be assumed as active (set to
Y
ES
) and begin transmitting data
packets. If set to
N
O
, the interface will not be put in the route table and will not be seen by other
devices on the network. This can be set to
N
O
if waiting on future turnup from Frame Relay provider.
Default is set to
Y
ES
.
DLCI
(This option is only available when the
L2 P
ROTOCOL
is set to
F
RAME
R
ELAY
.) This DLCI is the
number associated with the virtual circuit on the T1 interface. This number corresponds to the DLCI
number in the
L2 P
ROTOCOL
> C
ONFIG
> DLCI M
APPING
table.