ADTRAN TOTAL ACCESS 600R, Системное руководство

Страница: 121 / 196

Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 121
Router T1 Interface Setup
Before configuring the Router T1 Interface, choose
L2 P
ROTOCOL
and select
PPP
,
FRE
, or
A
UTO
. Setup
instructions for the
PPP
and
FRE
are described on the following pages. For information on setting the
L2
P
ROTOCOL
to
A
UTO
, reference DLP-014, Unit Installation Using The Auto-Config Feature .
Router T1 Interface Setup Instructions when L2 Protocol = PPP
Step Action
1 From the Main menu, select L2 P
ROTOCOL
and press E
NTER
.
2 Set the T1 [0] interface protocol to PPP.
3 Press Enter on the C
ONFIG
[+] option. Verify mode is R
OUTE
IP .
4
Press Enter on the A
UTHENTICATION
[+] option if you wish to change options
related to how the link is established. Default is T
X
M
ETHOD
= N
ONE
and RX
M
ETHOD
= N
ONE
. If TX M
ETHOD
and RX M
ETHOD
are set to any option other
than N
ONE
, TX/RX
USERNAME
and P
ASSWORD
options will appear.
5 Left arrow back to the Main menu.
6
Select router, select C
ONFIG
, select I
NTERFACES
, and select T1 [0]
SETUP
. Enter
WAN information:
• Far-End IP Address The far-end WAN IP address from the unit.
• IP Netmask The subnet mask for this WAN link
• Local IP Address The local WAN IP address for the unit.
The other config items can be left at the defaults.
7
For NAT configuration, please see the IP Routing with NAT section of this
appendix. On page 123.