ADTRAN TOTAL ACCESS 600R, Системное руководство

Страница: 130 / 196

130 © 2002 ADTRAN, Inc. 61200600L1-1A
Section 5 DLP-001 Total Access 600R System Manual
DLP-001
1. Connect a VT100 terminal to the unit.
2. Connect a PC emulating a VT100 terminal to the unit.
3. Most personal computers or laptops can run communications software that will emulate a VT100
terminal. Windows programs such as Terminal
©
or Hyperterminal
©
are two such examples in the
Windows format. However, there are many other adequate, commercially available software packages
which will allow your PC or laptop to emulate a VT100 terminal. Certain configuration items must be
set on a PC or laptop for it to act as a VT100 terminal for the unit.
4. Press <Enter> or <Ctrl + R> until the Login menu appears on screen.
You are now ready to log in to the unit, as described in DLP-002 , Logging in to the System.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Perform Steps Below in the Order Listed
• Set the parameters of the VT100 terminal to:
–
9600 baud rate
– 8 data bits
– No parity
– 1 stop bit
– No flow control
• If the terminal has a parallel setting, disable it and use serial port.
• Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by
using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make the connection to the VT100
terminal as appropriate for your equipment.
• Set the PC for direct connect on the appropriate com port (instead of dial-up connection).
• Set the parameters of the communications software to:
–
9600 baud rate
– 8 data bits
– No parity
– 1 stop bit
– No flow control
• Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by
using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make connection to the PC or lap-
top as appropriate for your equipment.
A VT100 terminal program is provided with the ADTRAN Utilities.