Adam Equipment Luna LAB 124 e, Руководство по эксплуатации

Страница: 32 / 48

© Adam Equipment Company 2020
The parameters that can be set are:
Enable On = serial port enabled
OFF = serial port disabled
Baud
Set Baud Rate. Selectable values    
Parity
Set Parity. Selectable values   
Stable
ON = print only when reading is stable
OFF = print regardless of stability
Continuous ON = Send data continuously over serial port
OFF = Only send data when
[PRINT] is pressed
Periodic
ON = Set the RS-232 to send data periodically. Range 1 to 999 seconds
OFF = No periodic data transmission
Format
Format of serial output data. Selectable parameter from:
SINGLE = Serial data output sent as a single line
STANDARD = Serial data output sent in standard format
FORM 1 = Serial data output sent in custom-designed format FORM 1
FORM 2 = or FORM 2 (See section 13.4).
13.4 FORMAT OF CUSTOM FORMS #1 and #2
If FORM1 or FORM2 is selected, the format be changed by the user using a selection of
available data. By default the 2 forms are the same as the standard form unless changed
by the user as below.
When  or  is selected, the user can set the information to be printed on each line
of the form. Pressing the [Up] or [Down] keys will cycle through the options available. The options
are:

Instrument ID number

Serial Number

Time

Date

Net Weight (Gross weight – Tare Weight)

Gross Weight

Tare Weight

Unit weight in parts counting mode

Number of items in parts counting mode

100% weight in percent weighing mode

Percentage of reference weight in percent weighing

Low Limit when check weighing (Not used)

High Limit when check weighing (Not used)

Inserts a blank line

Signifies the end of the report
(When END is entered the display returns to the
 Sub-menu)
Enter the data to be printed on the first line by pressing [Up] or [Down] to cycle through the
options. If the current information is OK then press [Setup] to move to the next line.
e.g   will print date on first line of output form.