Adam Equipment Luna LAB 124 e, Руководство по эксплуатации

Страница: 13 / 48

© Adam Equipment Company 2020
6.0 SETTING UP THE BALANCE
6.1 ASSEMBLING THE BALANCE
Carefully follow the below guide to assemble the balance. Ensure that you locate the
balance on a solid level surface, free from vibration.
6.1.1 Levelling the balance
After placing the balance in a suitable location, level it by
using the spirit level on the front of the balance. To level
the balance turn the two adjustable feet at the front of the
balance until the bubble in the spirit level is centred.
6.1.2 Warm-Up Time
Before you start weighing, you should allow the balance to achieve a stable internal
temperature. For accurate weighing to the manufacturer’s specification it is important to
power on the balance and allow to warm up for at least 6 hours for LBB + LTB models, and
12 hours for LAB + LPB models.
6.1.3 Weighing
Insert the power supply cable DC connector to the
connector on the rear of the balance. Plug the power
supply module into the mains and press the power switch
on the keypad to turn on the balance. The display will
indicate the balance serial number followed by the
software revision number, followed by the maximum
capacity of the balance. Next the balance will run a self-
test by displaying all segments followed by a busy symbol
and a line of 7 dashes indicating the balance is in busy
mode. Once ready, the display will show a zero weight
reading, accompanied by the
 0  symbol.
Once a suitable warm-up period is complete and you are
ready to start weighing, place an item to be weighed on
the balance. A stable symbol
is shown when the
balance is in stable condition. It will turn off if the balance
is not stable.
Exact zero is shown when the “
 0  “ symbol is visible
on the top left of the display area. [display photo changed]