Operator’s Guide for Rugged-UPS
TM
1252 Series
91-0120 Rev. B 6
© Acumentrics Corporation 2007-2008
Important Safety
Instructions
Save These Instructions. This manual contains important instructions that should be followed during
installation and maintenance of the UPS and batteries. Please read all instructions before operating the
equipment and save this manual for future reference.
WARNINGS
•
DANGEROUS VOLTAGE
is used in the operation of this equipment.
DEATH ON CONTACT
may
result if personnel fail to observe appropriate safety precautions.
•
There are
NO
user serviceable parts in this unit. Do
NOT
remove cover. Under no circumstances is
the top cover to be removed other than by the equipment manufacturer. Repairs are performed only
by factory trained service personnel.
•
The
Rugged-UPS
1252
series is designed to be deployed in environments where the unit may be
exposed to high humidity and precipitation; however, hardware damage or electric shock may result
if the unit is submerged during operation.
•
To prevent injury to personnel or equipment damage, the UPS requires two persons to lift and carry.
•
To reduce the risk of electric shock, disconnect the UPS from the mains before installing a computer
interface signal cable (when used). Reconnect the power cord only after all signaling
interconnections have been made.
•
Connect the UPS to a two-pole, three-wire grounding mains receptacle. The receptacle must be
connected to appropriate branch protection (fuse or circuit breaker). Connection to any other type of
receptacle may result in a shock hazard and may violate local electrical codes.
•
Do
NOT
obstruct the air intake in the front of the unit or the exhaust outlet at the rear of the
Rugged-
UPS
1252
. Sufficient airflow through the
Rugged-UPS
is vital to its operation.
•
This UPS has an internal energy source (the battery) that cannot be de-energized by the user.
The
output may be energized when the unit is not connected to a mains supply.
•
To properly de-energize the UPS in an emergency, move the Power ON switch to the OFF position
and disconnect the power cord from the mains and remove battery pack.
•
Avoid installing the UPS in locations where there is water or excessive humidity.
•
Do not operate or make electrical connections while standing near or within puddles of water. Avoid
installing the
Rugged-UPS
1252
in locations where the unit will be subjected to extended
exposure to water.
•
Do not allow water or any foreign object to get inside the UPS. Do not put objects containing liquid
on or near the unit.
•
To reduce the risk of overheating, avoid exposing the unit to the direct rays of the sun. Avoid
installing the unit near heat emitting appliances such as a room heater or stove.
Batteries
•
The batteries used by this UPS contain lead and pose a hazard to the environment and human
health if NOT disposed of properly. Proper disposal of the batteries is required. Please refer to local
codes for proper disposal requirements or return the unit to a factory authorized Service Center for
battery replacement or disposal.
•
Lead-acid batteries are used in this equipment. Do not use any battery which shows signs of
damage such as: bulging, swelling, disfigurement, brown liquid in plastic wrap, or inflated plastic
wrap and leakage.
•
Battery replacement should be performed by personnel familiar with the danger of batteries. Keep
unauthorized personnel away from the batteries.