Operator’s Guide for Rugged-UPS
TM
1252 Series
91-0120 Rev. B 15
© Acumentrics Corporation 2007-2008
Setup
•
Ensure the AC Circuit Breaker, located in the rear of the device, is OFF.
•
Connect ground wire to ground stud, located in the rear of the unit, and secure with wing nut.
•
Connect AC source to AC Input connector
•
Connect DC source to DC Input Connector.
•
Connect AC Load to AC Output Connector.
•
Connect DC Load to DC Output Connector.
SNMP Capability
and Operation
•
The Ethernet interface consists of a 10/100 Base T network interface using a standard RJ45
connector.
•
SNMP v3 protocol is supported with DHCP enabled.
•
The interface card has its own MAC address, which is included with the documentation.
•
The UPS supports a standard UPS MIB and may be accessed by using a MIB browser that
supports SNMP v3 . Refer to table 1 for supported features and default values.
•
The following is the SNMP v3 parameters for use with a MIB browser
Agent port - 161
Read community – Public
Write community – Private
Version – 3
USM user – “initial”
Authorized algorithm – MD5
Privacy algorithm – DES
Authorized password – none
Privacy password – none
MAC ID: 00:40:9D:2B:6C:FB (unique to each module and will be labeled on unit)
