Actidata actiLib Autoloader 2U, Руководство пользователя и обслуживания

Страница: 62 / 84

7.5 Removing and replacing the library controller
To remove a library controller:
Library controller is installed at the back of the library. Before you remove the library controller:
1. Turn off power to the library (power button on the front panel).
2. Remove the power cord cable.
3. Loosen the two captive thumbscrews on the library controller (see Figure 58).
Figure 58 Position of the two thumbscrews
4. Pull straight back on the library controller to remove it from the library (see Figure 59).
Figure 59 Library controller removal
Replacing the library controller:
1. Unpack the new library controller from its package.
2. Slowly insert the new library controller into the bay, and align the connectors on the library
while supporting the controller assembly.
3. Tighten the captive thumbscrews until the library controller is secure.
4. Replace the power cord cable.
5. Switch on power to the library (power button on the front panel).
The library controller maintains a backup of all Critical and Configuration Data separate from the
library controller, so that when replacing the library controller, the Critical and Configuration data can
be maintained and will not have to be entered manually again. When replacing a library controller, or
a chassis FRU, there will be a mismatch between the data on the library controller and the backup
data. When such a mismatch is detected, the user will be requested to determine which set of data is
correct.
If the library controller has been replaced, then select “Identity data mismatch” to copy the
backup data onto the library controller. If the chassis FRU or Robotics FRU has been replaced
(maintaining the original library controller), then select “Replace backup data”