Actidata actiLib Autoloader 2U, Руководство пользователя и обслуживания

Страница: 60 / 84

Figure 54 Tape drive removal
1
2 3
CAUTION: Push in on the tape drive handle while supporting the bottom of the tape drive until it is
properly seated. Damage to the connector pins may occur if this procedure is not followed.
To replace a tape drive:
1. Before installing the new drive, inspect the connectors on the tape drive. Ensure that the
connectors are intact, free of any foreign objects, and have no cracks or deformed or bent
contacts.
2. Slowly insert the new tape drive into the drive bay, and align the connectors on the library
while supporting the drive assembly (see Figure 55).
Figure 55 Installing a tape drive
2 3 1
3. Push the tape drive slowly into the drive bay until the drive seats itself against the back of
the library.
NOTE: If you are adding an additional tape drive to your library, or if you are upgrading an existing
drive, be sure to use supported cabling configurations.
4. Push the Product ID Foil back underneath the drive sled. When inserted properly, only the
handle of the Foil will be visible.
5. Tighten the captive thumbscrews until the drive is secure.
6. Connecting the power cable, SCSI cable and terminator.
7. Power on the library(or power on the drive refer to
“Changing the drive configuration”
on
page 49) using the power button on the front panel.
8. Run the Library Verify test.