Scope_manual_en-v110.docx
— 20 —
14.2.5
DESCRIPTION OF THE CONTROL AND SETTING OF A (B) CHANNEL PARAMETERS
Visualization of cursor measurement results
Information about the probe type connected to
the A and B channel input.
Position of channel A record.
Input sensitivity
setting
Note *)
Setting of the record
position in the window
where scanned courses
are displayed.
Channel switching on/off.
Switching of coupling for
the input signal (D/C or
A/C).
Position of channel B record.
Fig. 39
– Description of the control and setting of A and B channel parameters (figure applies to version 1.00) - see Fig. 40
Note *)
– see Chap. I - 14.7
SWITCHOVER OF CONNECTORS ON THE CHANNEL B
The motortester connectors
K2
,
K3
,
K4
and
K5
with attached probes can be connected to
the channel “
Ch-B
“.
By clicking on the “
Ch-B
“ button, you can gradually switch over between these connectors.
If a correct probe is connected to the connector, the connector will get attached. The description of the attached
probe is displayed on the “
Ch-B
“ button, e.g. the current probe of 500 A (see the cursor in Fig. 40).
Fig. 40
– View of the “Ch-B“ channel description when the current probe of 500A is connected
Tip for measuring:
If the connector
K5
(HV probe) is connected to the “
Ch-B
“ channel, you can monitor the course of HV voltage
(without any need to connect the synchronization sensor).
