Actia Multi-Diag Scope, Руководство пользователя

Страница: 15 / 84

Chap. I - Multi-Diag
Scope Basic User’s Manual
Scope_manual_en-v110.docx
— 15 —
Control panel
10
4a 4b 4c 4d
Buttons or opening
(stopping) the record,
cursor measurements and
automatic setup of the
oscilloscope's parameters
9
Buttons for saving, opening,
erasing, and printing of
waveforms
4
9a 9b 9c 9d
The selection of individual Multi-Diag Scope functional modes. By placing the
mouse cursor on the relevant icon and left-clicking, Multi-Diag Scope gets in the
selected functional mode
Motortester button. This mode
requires motortester module
connection
Buttons for
oscilloscope user setup
saving / loading
Record triggering control
and setting
Control and setting of input
sensitivity, A and B channel
switch-off
Button to invert the
displayed signal
Control and setting of time
base
Button to start
waveform
recording.
2
3
5
6
7
8
1
Fig. 33
– Multi-Diag Scope window after the program is started (figure applies to version 10.1)
Note to Fig. 33 - Links to the chapters describing the specific function:
1 ............... see Chap. II - Multi-Diag Motortester
2 ............... see Chap. IV - Record Analyzer
3 ............... see Chap. I - 14.2.15
4a ............. see Chap. I - 14.2.12
4b ............. see Chap. I - 14.2.11
4c ............. see Chap. I - 14.2.13
4d ............. see Chap. I - 14.2.14
5 ............... see Chap. I - 14.2.4
6 ............... see Chap. I - 14.2.5
7 ............... see Chap. I - 14.2.7
8 ............... see Chap. I - 14.2.6
9a ............. see Fig. 47, Chap. I - 14.2.17
9b ............. see Fig. 41, Chap. I - 14.2.17
9c ............. see Chap. I - 14.2.8, Chap. IV - 2.3.2
9d ............. see Fig. 47, Chap. I - 14.2.17
10 ............. see Chap. I - 14.2.2