14
TV C
HANNEL
S
ETUP
9. The channel scanning starts. This process may
take a few minutes.
10. When all the TV channels have been searched
and stored, press [SETUP] to exit.
Note:
If the available channel number in your residence area exceeds
the maximum receivable channel numbers of this DVD Recorder,
the scan will be discontinued. The maximum receivable channel
numbers are:
Antenna: 68 (chs)
Cable:
125 (chs)
Auto:
125 (chs)
Fine-tuning TV channels manually
After you have performed the channel scanning, you may like to
fine-tune the TV channel signal manually. Follow the steps below to
1complete fine tuning.
1. Press [SETUP] to display the Setup menu. Then, press
[
] [
] to select the “TV Tuner” icon. Press [
].
2. Press [CH ] [CH ] to shift channels.
3. Press [
] [
] to select “Fine Tune” and press [
].
4. Press [
] [
] to fine-tune the channel signal.
5. When complete, press [ENTER] and the press [SETUP] to
exit the setup menu.
Editing TV channels manually
After you have performed channel scanning, you may like to further
edit the TV channels. This function allows manually adding/deleting
channels, swapping channel order, inserting a channel to a specific
order, renaming the channels and so on.
1. Press [SETUP] to display the Setup menu, press
[
] [
] to select the “TV Tuner” icon and press [
].
2. Press [
] [
] to select “Utilities” and press [
].
3. Press [
] [
] to select “Edit Channel” and press [ENTER].
The Channel Editor menu will be displayed.
For detailed operation instructions on the “Channel Editor” menu,
refer to the “Channel Editor” section.
TV channel scanning
When the “Scan Channel” function is activated, the TV channels are
searched and stored in a specific order. If the channel assignment
of your TV content provider is changed, or if you are reinstalling this
DVD recorder, you may need to start this procedure again. This will
replace the TV channel stored with the new ones.
Before scanning channeld, set the “TV signal” and “Country” for
initiation.
1. Ensure the antennas are securely connected to
the DVD recorder.
2. Switch on the TV set and the DVD recorder.
3. Press [SETUP] to display the Setup menu, press
[
] [
] to select the “TV Tuner” icon and press
[
].
4. Press [
] [
] to select “TV Signal” and press
[
].
5. Press [
] [
] to select “Antenna,” “Cable” or “Auto”,
depending on how you receive your TV channels and
press [ENTER].
If you select “Auto,” the unit will automatically scan all channels
available at cable and antenna connections, which might take
longer than needed.
6. Press [
] [
] to select “Country” and press [
].
Press [
] [
] to select the country of your residence from
the list and press [ENTER] to save the settings.
7. Press [
] [
] to select “Utilities” and press [
].
8. Press [
] [
] to select “Scan Channel” and
press [ENTER] to start channel scanning.
If you wish to stop scanning, move to “Stop Scan” and press [ENTER].
The scanning process will be discontinued.
