AC S.A. All rights reserved. Copying, publishing, distribution and any usage of the full or partial data included in the herewith document, particularly pictures, drawings, illustrations, trade marks etc. is
strictly prohibited under the law.
Page 28 of 54
o
Intermediate phase –
controls the rate of switching individual cylinders to LPG
fueling (time when LPG and petrol are supplied simultaneously). Modification
recommended only when problems with smooth switching occur.
−
Very fast
–
cylinder switching occurs almost instantaneously.
−
Fast, normal, slow
–
steps for non-linear adjustment between “Very fast” and
“Very slow” values.
−
Very slow
–
the phase with LPG/petrol feeding overlap through 10 cylinder
working cycles.
o
Pressure error delay
– time, after which the controller switches to petrol, if the gas
pressure value is lower than the minimum value set in the calibration parameters
o
Min. gas temp.
– minimum gas temperature, below which the controller switches to
petrol
•
Sensors and actuators:
o
Gas injector type –
settings of the installed gas injector
Once the
button has been clicked, the following window, including gas injector settings, will
be displayed:
Figure 2.1.10
“Gas injectors settings” window
The window enables the user to set the correction rate individually for each section
of the injector as well as assign a given injector to a particular vehicle's Bank.
o
Lambda sensor 1 –
probe 1 type settings,
Voltage
– standard voltage probe,
UEGO
–
wide band UEGO probe
o
Lambda sensor 2 –
probe 2 type settings,
Voltage
– standard voltage probe,
UEGO
–
wide band UEGO probe
o
Reducer temperature sensor
– pressure regulator temperature sensor type
selection.
o
Gas level indicator –
gas level indicator configuration (description In section 2.1.12).