Alarm
56
Alarm Output
1. Click on “Alarm Output” in the “Alarm Settings”
menu.
Parameter
Setting
Alarm Output No.
Select the alarm output to make
the settings
Alarm Name
Enter a clear description here (e.g.
siren in warehouse)
Length
Length of the activated alarm
Schedule
Time-dependent control of the
alarm output
Copy To
Copies the settings
2. Assign the alarm output in the drop-down menu.
3. Enter the alarm name.
4. In the drop-down menu, enter the interval between
the alarm input message and the signal output on
the relay.
5. Select the day and enter the schedule (see page 42).
6. Copy the settings to other alarm inputs if the pa-
rameters match or if so required.
Note
If a network camera is used, then this must be set
up correctly and network access must be possible.
Pay attention to the information under
Manual
Alarm
on page 36.
IP alarm module
You can add up to three ABUS IP alarm modules
(CASA10010) here. After successfully connecting via the
network, two alarm inputs and two alarm outputs are
added to each of the “Alarm Input” and “Alarm Output”
tabs. The short name of the inputs is
U1<-1 / U1<-2, whilst the short name of the outputs is
U1->1 / U1->2.
Click on “Add” to configure an ABUS IP alarm module.
Parameter
Setting
UVM Name
A unique name for the IP alarm mod-
ule can be entered here.
IP Address
Enter the IP address of the IP alarm
module here.
Manage Port
Enter the port (default: 8000) of the IP
alarm module here.
Admin Name
Enter the user name of the IP alarm
module here (user must have admin-
istrator rights).
Password
Enter the password of the user speci-
fied above here.
After a successful connection two virtual alarm in- and
outputs are added. These can only be switch by network.
Note
Please refer to the homepage (www.abus-sc.com)
to find further installation instructions in the down-
load section of the ABUS IP Alarm Module
(CASA10000).
