Abus FUMO50110, Инструкция по установке и руководство пользователя

Страница: 79 / 267

Installation
79 | EN
Zone status and resistance values
Installer mode -> Test -> Zone resistance
Here you can see the number, name, allocated partitions, zone type and the actual re-
sistance value of the zone.
The resistance value changes when you open and close the alarm contact/tamper contact
of the zone.
Resistance ranges specified for idle, alarm and tamper states (in Ohms).
2-wire FSL
2K2/4K7 2-wire FSL
1K/1K 2-wire FSL
2K2/2K2 2-wire FSL
4K7/4K7
O/C tampering 8281-
∞
2401-
∞
5281-
∞
11281-
∞
Alarm 4081-8280 1401-2400 3081-5280 6581-11280
Idle 1760-4080 800-1400 1760-3080 3760-6580
S/C tampering 0-1759 0-799 0-1759 0-3759
4-wire CC 2-wire CC
Open/alarm/tampering 501-
∞
800-
∞
Closed/idle 0-500 0-799
Resistances immediately by the screw terminals.
The following parameters impact the actual resistance value of the detector circuit:
•
Line resistance of the cable
•
Resistance tolerances
•
Contact resistance at connections and switches
Recommended cable resistance: must be less than 100 ohms.
Note
The only difference between the wired zones on the alarm panel is:
500 ohms for 4-wire CC and 800 ohms for 2-wire CC in place of 1000 ohms.
You can find details on this in the installer manual chapter Technical data
– wired
zones in the appendix.
Installer mode > Test > Walk test
Here you can test the zone alarm and tampering.