Abus FUMO50110, Инструкция по установке и руководство пользователя, Страница: 64 / 267

Installation
64 | EN
PSU connections Hybrid module connections
10.5 - 15 V DC OUT 0 V / 12 V IN
1 - tamper PSU (if available)
Switch closed: OK
Switch open: Tamper
Z5 (example variant)
Zone 405
Zone type: Tamper
Programming is performed on the alarm
panel
Note the zone wiring.
2- fault 230 V (if available)
Switch closed: OK
Switch open: Fault 230 V
MAINS FAIL
otherwise jumper
3 - fault empty battery (if available)
Switch closed: OK
Switch open: Battery fault
LOW BATT
otherwise jumper
Note
Make sure the power supply unit cables are connected with the correct polarity.
Note
The wired zone type can be configured separately for each hybrid module.
The wired zone type applies to all 10 or 5 zones/inputs of the respective hybrid mod-
ule.
You can configure this setting in installer mode -> components -> hybrid module.
Note
You can configure the zone programming (type, name, partitions, properties) in in-
staller mode -> components -> HyMo zones