ABB TZIDC-200, Инструкция по эксплуатации

Страница: 47 / 68

TZIDC-200, TZIDC-210, TZIDC-220 DIGITAL POSITIONER | 42/18-85-EN REV. E 47
Parameter Display Function Possible parameter setting Unit Factory setting
P8._ ANLG_OUT
P8.0 MIN_RGE
Min. range Min. current range 4.0 to 18.4 mA 4.0
P8.1 MAX_RGE
Max. range Max. current range 20.0 to 5.7 mA 20.0
P8.2 ACTION
Action Direction of action of
characteristic curve DIRECT, REVERSE --- DIRECT
P8.3 ALARM
Alarm current Alarm message HIGH_CUR, LOW_CUR --- HIGH_CUR
P8.4 RB_CHAR
Readback character. Converted characters DIRECT, RECALC DIRECT
P8.5 TEST
Test Test Function --- NONE
P8.6 ALR_ENAB
Alarm function enabled Alarm via analog output ON, OFF --- ON
P8.7 CLIPPING
Current signal
Signal clipping range
Extension of signal output to
3.8 to 20.5 mA 4.0 to 20.0; 3.8 to 20.5 mA mA 4.0 bis 20.5
P8.8 EXIT
Return Return to operating level Function --- ---
P9._ DIG_OUT
P9.0 ALRM_LOG
Alarm logic Alarm output logic ACTIVE_HI, ACTIVE_LO --- ACTIVE_HI
P9.1 SW1_LOG
Switchpoint 1 logic Logic SW1 ACTIVE_HI, ACTIVE_LO --- ACTIVE_HI
P9.2 SW2_LOG
Switchpoint 2 logic Logic SW2 ACTIVE_HI, ACTIVE_LO --- ACTIVE_HI
P9.3 TEST
Test Test Function --- NONE
P9.4 EXIT
Return Return to operating level Function --- NV_SAVE
P10._ DIG_IN
P10.0 FUNCTION
Function select Function selection NONE, POS_0 %, POS_100 %, POS_HOLD --- NONE
P10.1 EXIT
Return Return to operating level Function --- ---
P11._ FS / IP
P11.0 FAIL_POS
Save position Safe position ACTIVE, INACTIVE --- INACTIVE
P11.1 FACT_SET
Factory setting Factory setting Function --- START
P11.2 IP-TYP
I/P module type Type of l/P module NO_F_POS,F_SAFE_1,F_SAFE_2,
F_FREEZE1, F_FREEZE2 --- [CUSTOM]
P11.3* IP_COMP
IP compensation IP compensation ON, OFF --- ON
P11.4 HART_REV
HART revision HART revision 5; 7 --- 5
P11.5 EXIT
Return Return to operating level Function --- NV_SAVE
* Activation by ABB Service only