ABB TZIDC-200, Инструкция по эксплуатации

Страница: 27 / 68

TZIDC-200, TZIDC-210, TZIDC-220 DIGITAL POSITIONER | 42/18-85-EN REV. E 27
M10436
1 2 3
Figure 11: Mounting the adapter on the positioner
1.  Determine the mounting position
(parallel to actuator or at 90° angle)
2.  Calculate the rotational direction of the actuator
(right or left).
3.  Move the part-turn actuator into the home position.
4.  Pre-adjust feedback shaft.
 To ensure the positioner will operate within the operating
range (see chapter
General on page 23), the mounting
position as well as the home position and direction of
rotation of the actuator must be taken into account when
determining the adapter position on the feedback shaft
1
.
For this purpose, the feedback shaft can be adjusted
manually so that the adapter
3
can be attached in the
correct position.
5.  Place the adapter in the proper position on the feedback
shaft and fasten with threaded pins
2
. One of the threaded
pins must be locked in place on the flat side of the feedback
shaft.
M10432
1
1
Attachment bracket
Figure 12: Screwing the attachment bracket onto the positioner
M10433
Figure 13: Screwing the positioner onto the actuator
Note
After mounting, check whether the operating range of the
actuator matches the measuring range of the positioner, see
chapter
General on page 23.