ABB SCU200, Руководство пользователя

Страница: 40 / 88

40
SCU200
INSITE ENERGY MANAGEMENT SYSTEM
→
Change adapter settings (on the left)
→
Ethernet
→
With right click select Properties
→
double click Internet Protocol Version 4 (TCP/IPv4)
→
Enter IP Address: 192.168.1.5 and Subnet Mask: 255.255.255.0 and confirm with OK.
Make sure that the IP address on the LAN is not already taken. In case it is taken, adjustments
are necessary. (192.168.1.x; x = 2…199, 201…255).
Now connect your device to the SCU200 control unit.
5.1.3.WiFi
The SCU200 can also be connected to a wireless Wi-Fi network. To do this, go to the System
setup – Communication – Wifi tab, turn on the Wi-Fi network interface and connect to the
selected network. For a secured network, you must also enter the password.
As with the wired Ethernet network interface, you can select between two modes for the
wireless Wi-Fi network interface - static and DHCP. The default mode is DHCP. After connecting
to the network, in the WebUI we can check what IP address has been assigned to the device
and through this address we can get to the web server. Of course, keep in mind that we must
also be on the same Wi-Fi network to do this.
The SCU200 can also be connected to a Wi-Fi network using the WPS button located on the
housing. To do this, an access point (usually a home router) must also have such functionality
and we must have physical access to it. To connect to such a network in an easy way, you need
to turn on the Wi-Fi interface on the SCU200 and click the WPS button. Then the Wi-Fi LED will
start blinking green and a time window will open for 2 minutes, during which we must press
the WPS button on the access point. When successfully connected, the Wi-Fi LED will turn
green and the SCU200 will be connected without even entering a password.