ABB IRB 6400R, Руководство пользователя онлайн

Страница: 95 / 481

Advanced Motion 3.2
Product Specification RobotWare for BaseWare OS 3.2 17
Contour tracking
Path corrections can be made in the path coordinate system. These corrections will take
effect immediately, also during movement between two positions. The path corrections
must be entered from within the program. An interrupt or multitasking is therefore
required to activate the correction during motion.
Example of application:
- A sensor is used to define the robot input for path correction during motion. The
input can be defined via an analog input, a serial channel or similar. Multitask-
ing or interrupts are used to read this information at specific intervals. Based on
the input value, the path can then be adjusted.
Independent movements
A linear or rotating axis can be run independently of the other axes in the robot system.
The independent movement can be programmed as an absolute or relative position. A
continuous movement with a specific speed can also be programmed.
Examples of applications:
- A robot is working with two different stations (external axes). First, a work
object located at station 1 is welded. When this operation is completed, station
1 is moved to a position where it is easy to change the work object and at the
same time the robot welds the work object at station 2. Station 1 is moved inde-
pendently of the robot’s movement, which simplifies programming and reduces
the cycle time.
- The work object is located on an external axis that rotates continuously at a con-
stant speed. In the mean time, the robot sprays plasma, for example, on the
work object. When this is finished the work area is reset for the external axis in
order to shorten the cycle time.
Friction Compensation
During low speed (10-100 mm/s) cutting of fine profiles, in particular small circles, a
friction effect, typically in the form of approximately 0.5 mm “bumps”, can be noted.
Advanced Motion offers a possibility of compensating for these frictional effects.
Typically a 0.5 mm “bump” can be reduced to about 0.1 mm. This, however, requires
careful tuning of the friction level (see User’s Guide for tuning procedure). Note that
even with careful tuning, there is no guarantee that “perfect” paths can always be
generated.
For the IRB 6400 family of robots, no significant effects can be expected by applying
Friction Compensation.