ABB ACH580-31, Руководство по оборудованию

Страница: 258 / 284

CAIO-01
± 11 V, ± 22 mA
AI-3
AI-4
AI-5
AO-3
AO-4
0-11 V, 0-22 mA
80 S HIELD
AI +VE
81
AI -VE 82
83
S HIELD
AI +VE
84
AI -VE
85
86 SHIELD
AI +VE
87
AI -VE
88
SHIELD
90
AO +
91
GND 92
SHIELD 93
AO + 94
GND 95
Start-up
￭ Setting the parameters
1. Power up the drive.
2. If no warning is shown,
•
make sure that the value of both parameters 15.01 Extension module type
and 15.02 Detected extension module is CAIO-01.
If warning A7AB Extension I/O configuration failure is shown,
•
make sure that the value of 15.02 is CAIO-01
• set the value of parameter 15.01 to CAIO-01.
You can now see the parameters of the extension module in group 15 I/O
extension module.
3. Set the parameters of analog inputs AI3, AI4, AI5 or analog outputs AO3 or
AO4 to applicable values, see the firmware manual.
Example: To connect supervision 1 to AI3 of the extension module:
• Select the mode of the supervision function (32.05 Supervision function 1).
• Set limits for the supervision function (32.09 Supervision 1 low and 32.10
Supervision 1 high).
• Select the supervision action (32.06 Supervision 1 action).
• Connect 32.07 Supervision 1 signal to 15.52 AI3 scaled value.
258 CAIO-01 bipolar analog I/O adapter module