AAQ AutoLift AL-6000A, Руководство по установке и инструкции по эксплуатации

Страница: 29 / 36

Maintenance
The several maintenance operations to be carried out are described below. A low
operation cost and a long life of the machine depends from constant observation of the
operations.
CAUTION: The listed intervention times are given for information and they refer to
normal operating conditions. They can change according to the kind of service,
environment (more or less dusty), frequency of use, etc. In case of heavier conditions,
servicing must be increased. When filling up or changing the hydraulic fluid, use the
same kind of oil used previously.
Periodical maintenance operations
9.1.1 EVERY WEEK

Check the cleanness of the mobile parts

Check the safety devices as previously described.

Check hydraulic fluid levels as follows

If maximum
lift
height is not achieved, check limit switch position, if ok check oil level, add oil.

Fill up through the filler cap using 32-45 viscosity hydraulic oil.

Check tension of foundation bolts (dyne bolts)
9.1.2 EVERY MONTH

Check tightening of screw.

Check the hydraulic system seal and tighten the loose unions, if necessary.

Check the hydraulic hoses condition. In case they are worn, replace them by new hoses of the
same kind.

Check the greasing and wear condition of pins, rollers, bushes of trolleys structure as well as arms
and relevant extensions. If necessary, replace the damaged parts by original spare parts.
9.1.3 EVERY 2
0
00 HOURS RUNNING

Empty the tank and check the condition of the hydraulic fluid. Clean the oil filter. If the
operations
are carried out with care, there will be an advantage for the user who will find the
equipment in perfect condition each time he restarts work.

Carry out cable adjustment, to level platforms by means of adjusting the nuts on the cable ends -
see figure below.
28