21
Serial & Telnet Commands
COMMAND
DESCRIPTION AND PARAMETERS
HELP
Show the full command list.
?
Show the full command list.
SET FACTORY DEFAULT
Reset the unit to the factory defaults.
SET FACTORY IPCONFIG
DEFAULT
Reset the unit’s network settings to the factory defaults.
SET FACTORY OUT ROUTE
DEFAULT
Reset the unit’s routing to the factory defaults.
SET POWER N1
Turn the unit on or place it into stand-by mode.
Available values for
N1
:
1 [Power on]
2 [Stand-by mode]
GET POWER
Show the unit’s current power state.
SET SYSTEM REBOOT
Reboot the unit.
GET FW VER
Show the unit’s current firmware version.
GET COMMAND VER
Show the unit’s current command version.
GET MAC ADDR
Show the unit’s MAC address.
GET MODEL NAME
Show the unit’s model name.
GET MODEL TYPE
Show the unit’s product type.
GET USER CONFIG
List the unit’s current configuration information.
GET ALL COMMAND INDEX
LIST
Show the unit’s full console command index list.
SET UART 1 RESET
Reset the unit’s RS-232 control port’s settings to the factory
defaults.
SET UART 1 BAUDRATE
N1
Set the baud rate of the RS-232 control port.
Available values for
N1
:
4800 [4800 baud]
9600 [9600 baud]
19200 [19200 baud]
38400 [38400 baud]
57600 [57600 baud]
115200 [115200 baud]
GET UART 1 BAUDRATE
Show the current baud rate of the RS-232 control port.
GET UART LIST
List all available RS-232 ports.
Содержание ANI-41STREAM
Страница 34: ...32 CONNECTION DIAGRAM ...
Страница 42: ...THIS PAGE IS INTENTIONALLY LEFT BLANK ...
Страница 43: ...THIS PAGE IS INTENTIONALLY LEFT BLANK ...