909 WLBCF310, Инструкция по эксплуатации

Страница: 28 / 42

26
WLBCF310 INSTRUCTION MANUAL www.909.com WLBCF310 INSTRUCTION MANUAL www.909.com
5. Wrap the line around the inside of the spool
(following the directional arrow on the
underside of the spool as indicated by the
“WIND CORD” and arrow). Ensure the line is
wrapped tightly and neatly. (Fig. AP)
6. When there is approximately 150mm of line left,
lock one of the lines into one of the line location
notches in the spool head and the other into
the opposing notch (Fig. AQ).
7. With the spring fitted onto the spigot of the
spool holder, insert the spool back into the
holder. As you insert the spool, thread the lines
through the eyelets (Fig. AR)
Make sure the metal washers are on each end
of the spring so the spring does not run on the
plastic surfaces.
NOTE:
When inserting the spool into the
housing, the spool may need to be rotated
slightly so as to locate into the housing.
Push firmly to ensure the inner spool of line is
fully inserted into the spool cover. This will also
unclip the line from the inner notches.
8. With the inner spool firmly held in place, the
outer cover needs to be fitted. Fit the outer
cover over the bump knob (34) by transferring
the pressure on the bump knob (34) from one
thumb to the other thumb through the centre
of the outer cover. (Fig AS)
9. Align the cover with the rear spool cover and
push and clip into position. (Fig AT)
When the cover is in place pull on the lines to
ensure the line is free from the inner notches.
If you are in doubt, refer to the section
“Advancing the line manually” on page 27 and
ensure the line is feeding.
RECHECK and ensure the outer cover is fully
clipped in place.
To install the spool and line assembly (35), refer
to ‘Fitting the Spool and Line Assembly on the
Line Trimmer” instructions on page 23/24.
AS.
AT.
AR.
AP.
AQ.