User Manual
| VISIX PTZ Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
6
2)
In the camera, assign a LAN IP address, the subnet mask and the gateway. Refer to
Section 2.1.2
Detecting
and Changing the IP Address
for detailed LAN configuration.
3)
In the router, set the PPPoE user name, password and confirm the password.
4)
Set port mapping. E.g. 80, 8000, and 554 ports. The steps for port mapping vary depending on different
routers. Please call the router manufacturer for assistance with port mapping.
NOTE:
Refer to Appendix 2 for detailed information about port mapping.
5)
Apply a domain name from a domain name provider.
6)
Configure the DDNS settings in the setting interface of the router.
7)
Visit the camera via the applied domain name.
!
Connecting the network camera via a modem
Purpose:
This camera supports the PPPoE auto dial-‐up function. The camera gets a public IP address by ADSL dial-‐up after
the camera is connected to a modem. You need to configure the PPPoE parameters of the network camera. Refer
to
Section 5.3.3
Configuring PPPoE Settings
for detailed configuration.
Figure 2-‐6
Accessing the Camera with Dynamic IP
NOTE:
The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes after
rebooting the camera. To solve the inconvenience of the dynamic IP, you need to get a domain name from the
DDNS provider (E.g. DynDns.com). Please follow the steps below for normal domain name resolution and
private domain name resolution to solve the problem.
NORMAL DOMAIN NAME RESOLUTION
Figure 2-‐7
Normal Domain Name Resolution
Steps:
1)
Apply a domain name from a domain name provider.
2)
Configure the DDNS settings in the
DDNS Settings
interface of the network camera. Refer to
Section 5.3.4
Configuring DDNS Settings
for detailed configuration.