3Ware 7000-2 - Escalade RAID Controller, Руководство пользователя

Страница: 68 / 196

3ware Escalade ATA RAID Controller User Guide
68 www.3ware.com
Windows NT
®
4.0
Installation
The Escalade ATA RAID Controller may be configured to be your
system’s boot device. Or, you can use another device such as a disk
attached to the motherboard as your boot device. Use your system’s
Setup utility to set the boot order according to how you install your
operating system.
If you are installing additional drives to a Windows NT system with
an existing Escalade ATA RAID Controller, follow the instructions
in:
Adding drives to an existing ATA RAID controller (page 69).
If Windows NT has not been installed on the system, follow the
instructions in either of the following sections (note: use of a boot
floppy diskette may be required by some systems):
Installing the ATA RAID controller and Windows NT 4.0
(page 70).
If you are installing the Escalade ATA RAID Controller on a system
that already has Windows NT installed on a drive connected to
another controller, follow the instructions in:
Installing the ATA RAID controller on systems that boot from a
different device
(page 74).
If you are replacing an installed Escalade ATA RAID Controller
with a new one, follow the instructions in:
Replacing an existing ATA RAID controller with a new version
of the controller
(page 76).
Note:
Windows NT 4.0 driver requires Service Pack 4 or
later. Also, you cannot install the driver or the operating
system without having system administrator privileges.