18
78-8130-6151-8 Rev G
E. Selecting External Jack [14] ([13] on 3M™ Dynatel™ Advanced
Locator 2250M) Frequencies
(Tone Frequencies)
A coupler can be plugged into the
External Jack
[14]
([13] on 2250M locator) of the receiver and used to
identify cables. (
See
Additional Applications: Cable
Identification
, Section 19B). The same procedure
as D. Enabling/Disabling Frequencies (above)
is followed for selecting frequencies that can be
detected by the
External Jack
[14] ([13] on 2250M
locator) found on the bottom of the receiver.
F. Creating User Defined Frequencies
There are four user defined frequencies available on the receiver. (These frequencies
must be between 50 Hz and 999 Hz.) These frequencies are found in the column on
the far right of the Locate Freq screen (Auxiliary frequencies). These frequencies, once
programmed, will appear in the Locate mode under the
Aux
[SK] frequency list when
Freq
[SK] is selected in the Locate mode.
To program the user defined frequencies press the
right arrow [SK] to highlight the Auxiliary group
of frequencies. Press the up/down arrows [SK]
to highlight the user frequency to program. Press
Enabl/Disabl
[SK].
Press the left/right arrows [SK] to move the square
cursor to a digit. Press
Select
[SK] to enter the
number in the frequency field.
Press
Locate/OK
[5] to save the programmed
frequency, or press
Exit
[SK] to cancel. The
frequency will appear in the locate frequency
screen as U ### , where ### represents the selected
frequency.
Note: To redefine a previously programmed user
frequency, highlight the frequency, press enabl/
disabl, select the back arrow with the cursor, and
press select to delete the previous entry.
