Pannoramic SCAN 150 1.17 User’s Guide
5 Troubleshooting and Maintenance
4.
Loosen pressure bolt with the lever (
1
) and by keeping the lever pressed, remove lamp
module (
2
) (see
Figure 73
).
Figure 73 – Removing the lamp module
5.
Carefully retrieve the new lamp module from its transporting container. Hold the lamp
module only by its ceramic part.
6.
Insert the new lamp module. Make sure that the groove (
1
) in the contact surface of the
lamp captures the corresponding pin of the lamp mount (see
Figure 74
).
Figure 74 – Inserting the lamp module
Caution!
Incorrect handling may considerably reduce the lamp
module’s useful
life. Hold it by the ceramic part in all cases! Never touch the lamp’s
glass surface or the inside surface of the reflector. Skin oil is harmful to
these parts.
7.
Re-establish plug-in connection.
8.
Tighten pressure bolt again with the lever.
9.
Screw the lateral cover-plate down to the housing.
10.
Connect power plug.
11.
Set hour meter (time counter) to zero.
July 4, 2013 - Rev. 1
3DHISTECH Ltd.
117(130)
