C-2
A
PPENDIX
C: S
AFETY
INFORMATION
Ensure nothing rests on the unit’s system cables and that the
cables are not located where they can be stepped on and
cause damage to the unit.
Keep the unit away from radiators and heat sources. Allow
25 mm (1 inch) around the unit or stack to provide
adequate air circulation.
Install the unit in a clean area that is free from dust or
extreme temperatures.
The unit has been designed to be a free-standing unit or
stacked with other OfficeConnect Remote units. Do not
place anything else on top of the unit’s case.
Allow a clearance gap of at least 50 mm (2 in) from the rear
panel of the unit, to allow for cable access.
This unit contains a lithium battery which is attached to a
microchip on the printed circuit board. The defective battery
must be disposed of safely in accordance with the
manufacturers instructions.
Cette unité contient une pile au lithium attachée à une puce
sur la carte à circuit imprimé. Se débarrasser de la pile
défectueuse en toute sécurité conformément aux instructions
du fabricant.
Normal operations of this unit could be interrupted by a
lightning surge. In this event, the user must recycle the
power to the unit in order to establish normal operating
conditions.
Important Safety Information
WARNING:
Warnings contain directions that you must follow for
your personal safety. Follow all instructions carefully.
Please read the following information carefully and thoroughly
before installing the unit:
Take exceptional care during the installation and removal of
the unit.
Locate the unit close to the main socket outlet, and ensure
that the main socket is accessible.
Use the power adapter supplied with the unit to ensure
compliance with national and international safety standards. If
there is no power adapter supplied, the main cordset used
must be compliant with the local and national regulations of
the target country and must not violate the safety approval of
the product (refer to the section at the back of this manual).
