3Com 3036, Руководство по настройке

Страница: 27 / 762

Command Line Interface (CLI) 23
The command line prompt character consists of the network device name (Router
by default) and the command view name, such as [Router-rip].
The commands are divided according to view. In general, in a certain view, only
the commands defined by the view can be executed, but some widely used
commands (including
ping
,
display
,
debugging
,
reset
,
save
,
interface
,
logic-channel
, and
controller
) can be executed in all views
For some views listed in the above table, you must enable the corresponding
functions before you can enter the views. To enter some other views, however,
you should configure the related restriction conditions. For more information, see
the related chapters in this manual.
In all views, you can use the
quit
command to return to the superior-level views,
and the
return
command to the system view directly.
Command Line
Online Help
The command line interface of the 3Com Router provides the following online
helps:
■
Full help
■
Partial help
X.25 hunt
group view Configures the X.25
hunt group parameters
[Router-X25-huntgroup-abc]
Enter
x25
hunt-group abc
round-robin
in
system view
Enter
quit
to return
to the system view
Frame Relay
class view Configures the FR class
parameters
[Router-fr-class-abc]
Enter
fr class
abc
in system view
Enter
quit
to return
to the system view
DLCI view Configures the DLCI
parameters
[Router-fr-dlci-100]
Enter
fr dlci 100
in synchronous serial
interface view. (The
link layer protocol
encapsulated on the
interface should be
FR.
Enter
quit
to return
to the synchronous
serial interface view
Frame Relay
switch view Configures the FR
switch parameters
[Router-fr-switch-abc]
Enter
fr switch
abc
in system view
Enter
quit
to return
to the system view
MFR interface
view Configures the MFR
interface parameters
[Router-MFR0]
Enter
interface
mfr 0
in any views
Enter
quit
to return
to the system view
L2TP group
view Configures L2TP group
[Router-l2tp1]
Enter
l2tp-group
1
in system view
Enter
quit
to return
to the system view
IPSec proposal
view Configures a security
proposal
[Router-ipsec-proposal-abc]
Enter
ipsec
proposal abc
in
system view
Enter
quit
to return
to the system view
IPSec policy
view Configures a security
policy
[Router-ipsec-policy-abc-0]
Enter
ipsec
policy abc 0
in
system view
Enter
quit
to return
to the system view
IKE proposal
view Configures an IKE
proposal
[Router-ike-proposal-0]
Enter
ike
proposal 0
in
system view
Enter
quit
to return
to the system view
ACL view Configures ACL rules
[Router-acl-1]
Enter
acl 1
in
system view
Enter
quit
to return
to the system view
DHCP address
pool view Configures a DHCP
address pool
[Router-dhcpabc]
Enter
dhcp server
ip-pool abc
in
system view
Enter
quit
to return
to the system view
View name Function Prompt Enter command Exit command