B. Assembly and Installation
Model AQSync Air Quality Monitoring Station Manual Rev. A-1
8
E. Slide the rubber gasket, white plastic washer, and nut onto
the Core. The narrow end of the black rubber gasket
should point downward. Secure the nut to the Shield
Assembly.
F. Slide the Inlet Cover onto the top of the Core. This requires a hard push and twisting
to get the Core through the internal o-ring that is inside the Inlet Cover.
G. The assembly is now complete except for
attaching the wires of the Core. At this point
the wires from the Core should be dangling
loose inside the AQSync. Near the back of
the AQSync, you should see two other
disconnected wires inside the AQSync that
mate to these connectors. One is a 3-pin
connector and the other is a 4-pin connector.
Match them up with the appropriate Core
wires and make the connections.
Done!
o-ring
Disconnected wires
Connected wires
Female
connectors
in back of
AQSync
Male
connectors
of the Core’s
wires
E
F
G
