ZyXEL Communications Prestige 2000W, User Manual

Page: 57 / 81

Prestige 2000W User’s Guide
11-2 User Access to the Prestige
11.2 Network Configuration: STATIC
If you were assigned a specific IP address for your Prestige, use the following directions to set your Prestige to use it.
Figure 11-2 STATIC Network Configuration
Table 11-2 STATIC
LABEL DESCRIPTION
Get IP Address Click STATIC to manually enter a fixed IP address in the NetWork IP field.
Click DHCP to have the Prestige automatically obtain network settings at startup from a
Dynamic Host Configuration Protocol server. These settings are not configurable.
Click PPPoE if your network supports Point-to-Point Protocol over Ethernet to automatically
configure your Prestige.
NetWork IP This is IP address your Prestige uses to connect to the wireless LAN. Type the address given to
you by your network administrator.
NetWork Subnet
Mask
The subnet mask specifies the network number portion of an IP address. Your Prestige
automatically calculates the subnet mask based on the IP address entered in the NetWork IP
field. Unless you are implementing a subnet, use the subnet mask computed by the Prestige
255.255.255.0.
NetWork Default
Gateway
Type the gateway IP address of the device to which you want to connect your Prestige.