ZyXEL Confidential
12/34
[Condition]: 1. "wan node index 2".
2. set both the vpi and vci value same as pvc 1.
3. wrong message will be showed or device will crash.
22.
[Bug Fix]
[Symptom]: CLI command "ip route addrom active off" can not work.
[Condition]: N/A
23.
[Bug Fix]
[Symptom]: Load firmware using HyperTerminal, System will show "checksum error"
after running "put rom-0 rom-d". while using procomm to load firmware it will work
ok.
[Condition]: Using different console tool.
24.
[BUG FIX]
[Symptom]: Enable tripleplay, and set above two route PVCs, the LAN pc will always
go out through PVC1.
[Condition]: 1. Enable tripleplay, map port1 to PVC1 with PPPoE dynamic IP, map
port2 to PVC2 with ENET dynamic IP. Both PVC get an available IP. The LAN pc
connects with port2, but goes out through PVC1.
2. Enable tripleplay, map port1 to PVC1 with PPPoE dynamic IP, map
port2 to PVC2 with ENET dynamic IP. ONLY PVC1 get an available IP. The LAN pc
connects with port2, but goes out through PVC1. if the PVC2 get an available IP, pc
can go out through PVC2.
25.
[BUG FIX]
[Symptom]: In wizard after config route RFC1483 or bridge RFC1483 ,no wireless
setting steps
[Condition]: In wizard after config route RFC1483 or bridge RFC1483 ,no wireless
setting steps
26.
[BUG FIX]
[Symptom]: Device will show exception
[Condition]: 1.In GUI change system name and save
2. Use CI command change baud rate.
3. Restart device will exception or other wrong Symptom.
27.
Change default rom file.
Replace “wan dmt2 db tlb 10” by “wan dmt2 db tlb 25” and add “wan dmt2 set largeD 2”
in autoexec.net for TR100.
Modification in 3.40(APR.2)C0 | 01/14/2008
2.
Change to FCS
Modification in 3.40(APR.2)b2 | 12/20/2007
1. [Bug Fix]
[Symptom]: When MBM is enable, after wireless connect to device, LAN PC cannot
resolve DNS.
[Topology]: PC1------------wired-------------P660HW
-
T1
v2-------------Internet
PC2------------wirelessLAN-------------P660HW-T1 v2-------------Internet
[Condition]:
