ZyXEL Confidential
11/34
Step1. Configure two routes with dynamic IP.
Step2. Mapping LAN 1 to PVC 1 and leave PVC2 unmapped.
Step3. LAN 1 can go out successfully through PVC1, but LAN 2~4 can’t go out by
PVC2.
Step4. Add another group mapping LAN 2 to PVC2 and try it again, LAN 2 can go
out through PVC2.
Step5. If you map LAN 1 to PVC 2 and leave PVC1 empty in Step2. LAN 2~4 will
go out through PVC1 successfully.
15.
[BUG FIX]
[Symptom]:Unix Syslog doesn't work when longin/logout the CI cmd, the software of
Kivi Syslog cannot receive any message.But the F/W with SMT have those messages.
[Condition]: N/A
16.
[BUG FIX]
[Symptom]: In WLAN page. Advance Setup could save the security mode setting
[Condition]:
1. In WLAN page. DUT set "no security" in security mode and apply
2. STA could connet to DUT with no security
3. Changed the DUT setting to "WPA-PSK" without click apply button. Only click
the Advance Setup button
4. The DUT's status had changed to "WPA-PSK" security mode
5. WPA/WPA2/WPA2-PSK had the same issue
17.
[BUG FIX]
[Symptom]: Remote MGMT lack of log Message body
[Condition]:
1. In eWC Remote MGMT>FTP/HTTP/TELNET/SNMP/DNS Access
Status=Disable, and LAN PC ftp to DUT(192.168.1.1).
2. Check log had this record, but message body is null, message body should be
show "Remote Management: FTP denied"
18.
[Bug Fix]
[Symptom]: When do IPTV, wireless can’t access internet.
[Condition]: Triple pay setting: Group1: PVC1----LAN 1,2 and wireless (pppoe route
internet use);Group2: PVC2 ---- LAN 3,4 (bridge mode, IPTV use)
19.
[BUG FIX]
[Symptom]: When PPPoE set up, the PADI broadcast packet will send to LAN side.
[Condition]: When PPPoE set up, the PADI broadcast packet will send to LAN side.
20.
[BUG FIX]
[Symptom]: When CPE receive a DHCP NAK packet, it will never get IP from DHCP
server in the WAN side.
[Condition]:
1. Set Encapsulation = ENET Enacp.
2. CPE get IP from DHCP server in the WAN side.
3. CPE will send DHCPREQUEST when renewal time expires.
4. CPE will will never get IP from DHCP server if it receives a DHCPNAK packet.
21.
[Bug Fix]
[Symptom]:Using CI command to set pvc2 with the same vpi and vci value withe pvc 1,
wrong warning message will be showed and in some cases device will crash.
