ZyXEL Communications Internet Security Gateway ZyWALL 100, User Manual

Page: 470 / 708

ZyWALL Series Internet Security Gateway
32-2 Filter Configuration
Figure 32-1 Outgoing Packet Filtering Process
For incoming packets, your ZyWALL applies data filters only. Packets are processed depending upon
whether a match is found. The following sections describe how to configure filter sets.
32.1.1
The Filter Structure of the ZyWALL
A filter set consists of one or more filter rules. Usually, you would group related rules, e.g., all the rules for
NetBIOS, into a single set and give it a descriptive name. The ZyWALL allows you to configure up to
twelve filter sets with six rules in each set, for a total of 72 filter rules in the system. You cannot mix device
filter rules and protocol filter rules within the same set. You can apply up to four filter sets to a particular
port to block multiple types of packets. With each filter set having up to six rules, you can have a maximum
of 24 rules active for a single port.
Sets of factory default filter rules have been configured in menu 21 to prevent NetBIOS traffic from
triggering calls and to prevent incoming telnet sessions. A summary of their filter rules is shown in the
figures that follow.
The following figure illustrates the logic flow when executing a filter rule. See also
Figure 32-7 for the
logic flow when executing an IP filter.
Data
Filtering
Outgoing
Packet
Drop
packet
Built-in
default
Call Filters
User-defined
Call Filters
(if applicable)
Initiate call
if line not up
Active Data
Send packet
and reset
Idle Timer
Or Or
Drop packet
if line not up Drop packet
if line not up
Send packet
but do not reset
Idle Timer
Send packet
but do not reset
Idle Timer
Match Match Match
No
match
No
match
No
match
Call Filtering