Cable/DSL Broadband Router w/4-Port Switch
19
4. Configuring the Router
Before you configure this device, note that when the Broadband Router is
configured through an Ethernet connection, make sure the host PC must be
set on the IP subnetwork that can be accessed by the Broadband Router.
For example, when the default network address of the Broadband Router
Ethernet interface is 192.168.10.x, then the host PC should be set at
192.168.10.xxx (where xxx is a number between 2 and 254), and the
default subnet mask is 255.255.255.0.
1.
Open an Internet Explorer (or other web browser), type
“192.168.10.1” in the address bar, and then press “Enter”.
2.
Input “admin” for the User Name, and “admin” for the
Password, and then press OK.
Figure 4-1
NOTE:
By default the user name is “admin” and the password is “admin”. For
security reasons it is recommended that you change the password as
soon as possible (In Login ID & Password Setup).
This router provides web browser management mode. Login the Router,
The HOME page screen below will appear. The Home Page is divided into
eight sections, Status WAN Setup, LAN Setup, Routing, NAT, Fire Wall,
Summary of Contents for ZSR0104CP
Page 1: ......