18
3.3 I Installing the sensors on the POD kit
•
Screw down the one or more sensor holders onto the POD kit,
see illustrati on
.
•
Carefully unscrew the protecti on tube from the sensor,
see illustrati on
. Retain the protecti on tube for
use when the sensor is stored during the winter.
•
Rinse the end of the sensor with tap water and shake off excess water,
see illustrati on
.
• Never wipe the sensor using a cloth or paper ti ssue, as this may damage it!
• A badly-installed sensor may give false readings and cause inappropriate operati on of the
appliance. Neither the manufacturer nor the appliance shall be liable in this event.
•
Screw the sensor into the sensor holder, holding the BLUE or YELLOW connector in one hand and the black
connector in the other to avoid tangling the cable,
see illustrati on
.
•
Once the sensor is installed on the POD kit, it can be connected to the BNC connector (BLUE = pH; YELLOW
= ORP) on the pH Link or Dual Link module,
see
“2.5.3 Electrical connecti on steps”,
see illustrati on
.
•
Then the sensor is ready for calibrati on, see
“5.3 I Calibrati ng the sensors (if an opti onal pH Link or Dual
Link module is installed)”
EN
