SW3-L3
GIGABIT/FAST ETHERNET SWITCH/ROUTER TYPE SW3-L3
99/180
USER GUIDE - M0SW3M1902Iv07 - V06 February 2019
•
Size of ICMP packets.
This allows the size of the ICMP packet to be specified.
The configuration consists of indicating the extra bytes to be added to the smallest
ICMP packet, which is, by default, 28 bytes.
•
Number of ICMP packets.
This allows the number of ICMP packets that are sent
in each verification to be specified.
•
Evaluation Model.
This sets the model for the evaluation of the accessibility test.
The options are:
single
and
period
. The
single
model specifies that, if some
execution of the test fails, the behaviour of the equipment is the one defined in the
Action
parameter. The
period
model specifies, by means of the two following
parameters, a test evaluation period and an admitted failure percentage within it.
•
Evaluation Period (min).
When the Evaluation Model parameter is configured as
period,
this sets a period between
1
and
6000.
All the responses to the
Ping Keep
Alive
packets sent in this period make the universe of samples that will be
considered to decide about the execution of
Action
according to the fulfilment of the
criteria selected by means of the following parameter.
•
Max Lost Ratio (%).
This allows the maximum admitted percentage of failure in
the Evaluation period to be specified for the results of the Ping Keep Alive
messages.
•
Action.
This selects the desired behaviour of the equipment when the supervision
function fails. The available actions are:
None
(no action taken) or
vrrp2master
(forcing priority to 255).
5.12
SNMP CONFIGURATION
The equipment has an SNMP agent with the capacity to generate spontaneous messages
to control devices, based on that protocol.
The agent admits the emitting of messages based on the SNMPv1 [3], SNMPv2c [4] and
SNMPv3 protocol, and the selection of the type of message,
trap
and
inform
.
Changes made to the SNMP agent configuration will
only
be active after
RESETTING
the equipment. The
Apply
command is not sufficient, and so the changes must
previously be saved using the
Save
command before requesting the reboot.
