SW3-L3
GIGABIT/FAST ETHERNET SWITCH/ROUTER TYPE SW3-L3
30/180
USER GUIDE - M0SW3M1902Iv07 - V06 February 2019
2.6
SFP PORTS
The bays available in the front plate of the equipment admit the installation of SFP (Small
Form Factor Pluggable) modules, which provide optic Gigabit Ethernet interfaces to the
switch; the characteristics of the fiber optic to be used, as well as the type of connector, will
depend on the SFP model used. See the available modules in section 1.4.3,
Accessories
.
Bays have a protective cap.
FIGURE 17
SFP modules
Inserting procedure of an SFP module
The inserting procedure of an SFP module is the following:
1.
Remove the protective packaging of the SFP module.
2.
Check that the SFP module is the correct one for your network configuration.
3.
Hold the module between your thumb and forefinger.
4.
Insert the module into the corresponding SFP slot on the front panel of the equipment.
5.
Remove the protective caps from the optical ends of the module.
6.
Insert the fibers, in the optical ends of the module, keeping in mind the TX and RX data
transmission directions (see FIGURE 17).
