SIP-2
88/145
USER GUIDE - Rev. 3 (January 2018)
Protocol.
It establishes the protocol of the data to be encapsulated; the possible
values are indicated at the beginning of section 5.16.1. Usually the virtual ports
operate in
raw
mode; the corresponding physical port is configured with the desired
protocol.
Policy.
This field should be configured when the
policybased
mode has been
established in the
Protocol
parameter. It establishes an identifier, whose policy
should be configured in the
Policy
submenu of the
Flow
menu.
Packed time (ms).
See description at the beginning of section 5.16.1.
Packed size.
See description at the beginning of section 5.16.1.
TLS.
It establishes if the TCP connection will use ciphered communications
through Transport Layer Secure (TLS).
Password.
Related to the use of TLS, it establishes the common basic password.
•
RFC2217.
It establishes if the TCP connection should operate with the serial
interface control extensions established in the RFC2217, or not.
Enable.
It establishes if the TCP connection is active or not. The acceptance of
TCP connection requests is enabled, if the box is ticked. When unchecking the box,
the TCP connection requests will be rejected.
•
RX UDP (UDP ports that will accept data).
#.
It is a sequence identifier provided by the equipment itself.
Identifier.
It establishes a different and unequivocal name for each one of the UDP
virtual ports where the data packets will be accepted. When added, all the ports
have the name
rxudp0
configured by default and, therefore, it is essential to assign
a specific name to each of them.
Interface.
It establishes the possible interfaces the data will be accepted on;
therefore, it restricts the possible input points of the packets. The possible values
are the following: all, eth0 or cell0, if the equipment has the WAN interface.
Port.
It establishes the UDP port to be used to receive packets.
Group-ID. Multicast
IP address that will accept data in reception, as long as the
parameter value is a valid address, and the
multicast
option is active. The
0.0.0.0
default value is not a valid IP address.
Source Address.
It establishes the source IP address range from which the
connection requests will be accepted. It acts as filter of the authorized source
equipment. The address may be a host or network address; therefore, it is
necessary to specify the IP network mask.
