39
3.5.1. OnChip IDE Device
Press <Enter> to set IDE and SATA device configuration.
Item Help
Menu Level
↑↓
←
→
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
IDE HDD Block Mode
IDE DMA transfer access
*** On-Chip Serial ATA Setting ***
SATA Mode
On-Chip Serial ATA
*** On-Chip PATA Setting ***
On-Chip Primary PCI IDE
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
Phoenix
– AwardBIOS CMOS Setup Utility
OnChip IDE Device
If your IDE hard drive
supports block mode
select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support.
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
[
Enabled
]
[ Enabled ]
[ IDE ]
[ Enhanced Mode ]
[ Enabled ]
[ Auto ]
[ Auto ]
[ Auto ]
[ Auto ]
[ Enabled ]
[ Auto ]
[ Auto ]
[ Auto ]
[ Auto ]
□
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sectors
read/write.
□
IDE DMA transfer access
UDMA (Ultra DMA) is a DMA data transfer protocol that utilizes ATA commands and the
ATA bus to allow DMA commands to transfer data at a maximum burst rate of 33 MB/s.
Summary of Contents for POP-950-D5
