17
2.6.3. Dip Switch Configuration of the Receipt Printer
In general, the receipt printer unit is pre-installed on the POS system and need not change the
settings. To change the setting of the printer, Please follow the steps as follows:
The Securing Screw of Receipt Printer
The Dipswitches of Receipt Printer
(bottom)
a. Switch off the power and carefully lift up
the POS system.
b. Disconnect the cables from the I/O ports
of the printer unit.
c. Loose the securing screw on the
bottom-left of the POS system
(as image below illustrated).
d. Pull up to unhook the printer unit and
then pull to detach the printer.
e. Turn over the printer unit and open the
cover of DIP Switch Cover
(in the bottom of receipt printer unit)
Securing Screw
Securing screw
I/O Ports of
Printer
Summary of Contents for POP-950-D5
