18
INSTALLATION INSTRUCTIONS & USER MANUAL
804428UK V1.03 OCT 2017 - ZIP EP HYDROTAP
TECHNICAL SUPPORT
TEL: 0345 6 005 005 EMAIL: SERVICE@ZIPINDUSTRIES .CO.UK
WWW.ZIPWATER.CO.UK
USING THE ARC & CUBE TAPS
Warning lights
When both Filter and Boiling water lights are flashing , the system has experienced a fault. Turn the power to the
Command Centre OFF for at least 15 minutes. When the power is turned ON the system may revert to normal
operation. If all the lights continue to flash then there is a system fault which must be rectified by an authorised
service agent.
USING THE BOILING CELSIUS TAPS
5.2 HydroTap Celsius tap operation
The Celsius tap is only configured to dispense boiling water
when used with the Command Centre.
To dispense boiling water
Touch the red illuminated safety button twice, it will flash for a few
seconds. While the safety lock is flashing turn the rotary control
anticlockwise or clockwise as shown in the adjacent diagram.
The integral safety lock cannot be disabled.
Indicator
light
Safety
button
To dispense mixed hot and cold water
The mixer tap lever is operated as a conventional ‘flick mixer’. The hot
direction is marked with a red dot and the cold direction with a blue dot,
for dispensing cold to warm water.
Moving the lever towards the tap will decrease the flow rate and moving
the lever away from the tap will increase the flow rate.
When the lever is moved in the direction of the blue dot, the temperature
is decreased and when moved in the direction of the red dot, the
temperature is increased. The final temperature will be dependant on the
temperature of the incoming cold water. The spout may be swivelled, left
or right, for convenience.
Tap lights
The red illuminated warning light will flash slowly for 1 second ON and 4 seconds OFF whenever the water is not at
the temperature set point. The tap may be operated, but the water may not be at the desired temperature . The slow
flashing light will turn off once the water reaches the set point. The set point temperature is user adjustable.
